Installation Guide

Read this installation entirely before you begin. The installation of Peel & Stick Tile is an "easy-DIY"project. If you doubt doing this installation, you should contact a qualified and professional installer.

What You'll Need
• An all-purpose wall cleaner
• A Sof cloth
• A sharp scissors or craft knife, Jig saw or chop saw (recommended)
• A Pencil and ruler

1. Clean the surface
The suface should be free of oil grease, dust and dampness, Uneven surfaces such as rough or curved wall is not recommended.
Always clean your backsplash area to remove grease and any other residue. After the area gets dry, you can start working.

2. Measure The Wall
Measure the area to be covered, Lay out the entire project on a flat surface before installing the tiles to be sure you have enough tiles and your design is correct. Using a chalk line, create at least one vertical and one horizontal reference lines to guide tile placement.

3. Cut The Tile

  • If cutting tiles is necessary, using a chop sawis the recommended cutting method. Be sure to follow all safety procedures, includingusing safety eyewear, when using saw.
  • Alternative cutting method is using utility knife with ruler to make scores on the tile and snap off, Cut off the adhesive tape on the back with utility knife. Take the cut tile to the work space and place it in its intended location, ensuring it fits properly before removing the protective film on either side ofthe tile.
  • The cutting method depends on the tile material. For example, simple scissors will cut vinyl tile, while harder materials can require a chop sawis.


4. Peel, stick and Press
Remove the release film from the back of the tile. Make sure you don’t touch the adhesive portion. Attach the tiles on the desired position by applying pressure.

5. Finishing Touches.
Press each again firmly with hand. This will ensure that the adhesive bonds to the substrate. Clean tiles with water and
soft cloth.


Important Tips
Please consider 3-5% cutting loss and purchase enough tiles at a time to make sure they come from the same batch to avoid slight color difference.